Handy Plumbing Tips and Tricks

Here are nine of our favorite simple tricks and tips to save you plumbing headaches a  

 

To save you time, money and headaches down the road, we collected our favorite tips and tricks for solving common household plumbing problems. Most of these tips make use of things that cost less than $20 and these tips could save you an expensive service call.

By the DIY experts of The Family Handyman Magazine

Stop sink-sprayer hang-ups

Use pipe insulation to prevent sprayer snarls

If you have to jiggle the hose as you pull out your kitchen sink sprayer, chances are the hose is catching on the shutoff valves. For smooth operation, slip 1/2-in. foam pipe insulation over the pipes and shutoff handles. Tape it if it won't stay put. Get the insulation at home centers for about $3.

Silence creaking pipes

Wrap pipes in adhesive-backed felt

Running hot water can cause copper pipes to expand and grind against pipe hangers and joists. So pick up some adhesive-backed felt at the hardware store and cut it into strips. Then remove each hanger and wrap the pipe before refastening the hanger.

Quiet loud sinks

Deaden sounds with expanding foam

Fill the space between two stainless steel sink basins with expanding foam. The foam deadens vibrations and lessens the gong effect. It's possible to do this with the sink in place but much neater and easier before installation. Either way, let the foam harden and then trim away the excess with a knife.

Drain vacuum

Use a shop vacuum to remove hard objects

When a hard object like a toothbrush, comb or toy plugs a toilet or drain, a plunger may not be the solution—it might only push the obstruction in deeper. Instead, suck out the water and the obstruction with a wet/dry shop vacuum.

Pipe orienteering

Use a strong magnet to find hidden pipes

When trying to locate a pipe under the floor, attach a rare earth (neodymium) magnet to an electrical fish tape and feed it into drain lines through the cleanout plug. Locate the magnet (and the pipe) under the floor using an ordinary compass, which will turn wildly when it finds the strong magnet.

Bucket flush

Use a bucket of water to flush the toilet

You don't have to run to the neighbor's bathroom during a plumbing project. Before you turn off the water supply, fill 2- gallon buckets with water. Flush the toilet by dumping the water in the bowl. You'll get one flush per bucket. Works just as well as the usual method, although it won't refill the bowl.

Next best thing to X-ray vision

Take a picture before closing up walls

Your walls may not have much inner beauty, but it's a good idea to take pictures of what's inside during remodeling. The same goes for floors and ceilings. When your next remodeling or repair project rolls around, you'll know where the framing and the electrical and plumbing lines are.

Empty the trap

Plunge water first before removing the trap

Before you remove a sink trap, give the drain a few plunges with a toilet plunger. This will push most of the water out of the trap, lessening the mess when you pull the trap. If you have a double sink, be sure to plug the other drain to contain the air pressure. If the strainer isn't a screw-down style, you'll have to hold it down while you plunge the drain.

Inside view

let a look at hidden spaces

Whether you're remodeling or just running wire, knowing what's inside the walls is helpful.